|
(800) 967-3929
 |
|
|
Setting up the Roland GX-24 for Axis Swap
By
default, the new Roland GX-24 plotter is setup for cutting from left
to right, rather than cutting tdown the length of the roll. Most sign
specific software, such as SignLab, FlexiSign, and ProDeSIGN expects
the orientation to run the length of the roll. Roland calls this Rotate
0 or Rotate 90. To change the default, follow these instructions:
Load material in the machine.(the display
will say SETUP SHEET,
and ROLL
Press ENTER
(Note that the cutting head will stop on the left hand side of the
machine.)
Press MENU
button twice
Press DOWN ARROW
once (the top of the display says CONDITION)
Press the RIGHT ARROW
once (the top of the display says FORCE)
Press the UP ARROW
twice (the top of the display says ROTATE)
Press the RIGHT ARROW
once (the bottom of the display says 0 deg)
Press the DOWN ARROW
once (the bottom of the display says 90 deg)
Press ENTER
Press the MENU
button twice (the top of the display says UNSETUP)
Press ENTER
(the display says SELECT SHEET >ROLL)
Press ENTER
(Note that the head will now scan the size of the vinyl and stop
on the right side of the material.)
THAT'S IT!
|
